Taper Turning: The amount of taper in the workpiece is usually specified on the basis of the difference in diameter of the taper to its length. It is known as a cone and it is indicated by the letter K. It has the formula K = D-d / 1 to produce the taper on the workpiece. […]
SOME IMPORTANT TYPES OF LATHE OPERATION Read More »
The lathe machine operations are classified into three main categories and are as follows Following are the Lathe machine operations done either by holding the workpiece between centres or by a chuck:Turning Operation between centres or by a chuck:Turning Operation FACING It is an operation of reducing the length of the workpiece by feeding the
Some Important types of Lathe Operations Read More »
An engineer’s vise, also known as a metalworking vise, machinist’s vise, or, informally, a “bench vise”, is used to clamp metal instead of wood. It is used to hold metal when filing or cutting. It is sometimes made of cast steel or malleable cast iron, but most are made of cast iron. BENCH VICE PARTS 2.
What are the Parts of a Vice ? Read More »
ED with Er. Neelakantheswar Biswal, Vice-Principal of Koraput ITI.
Engineering Drawing Read More »
